#ROUTER ON A STICK PACKET TRACER MAC#

Refer to the Address Table and assign the correct IP address to the subinterface.Set the encapsulation type to 802.1Q and assign VLAN 10 to the subinterface.Part 3: Configure Subinterfaces Step 1: Configure subinterfaces on R1 using the 802.1Q encapsulation. Why were the pings unsuccessful? Each VLAN is a separate network and requires a router or a layer 3 switch to provide communication between them. Issue the show vlan brief command to verify VLAN configuration.ДЎ default active Fa0/1, Fa0/2, Fa0/3, Fa0/4ДЎ005 trnet-default active Step 3: Test connectivity between PC1 and PC3.ДЇrom PC1, ping PC3.S1(config-if)# switchport access vlan 30.S1(config-if)# switchport access vlan 10.Configure interface F0/6 and F0/11 as access ports and assign VLANs.S1(config)# vlan 10 S1(config-vlan)# vlan 30 Step 2: Assign VLANs to ports. Return to Realtime mode and create VLAN 10 and VLAN 30 on S1. Part 2: Add VLANs to a Switch Step 1: Create VLANs on S1.

#ROUTER ON A STICK PACKET TRACER MAC#

Without a MAC address, PC1 cannot create an ICMP echo request. PC1 and PC3 are not on the same network, so S1 doesnвЂ™t forward PC1вЂ™s ARP request (a broadcast packet) to VLAN30. What process failed and why? The ARP process failed because the ARP request never reached PC3. Click Capture/Forward to see the steps the ping takes between PC1 and PC3.Switch to Simulation mode by clicking the Simulation tab or pressing Shift+S.Step 2: Switch to Simulation mode to monitor pings. Because the two PCs are on separate networks and R1 is not configured, the ping fails. When the link lights are green for PC1 and PC3, ping between PC1 and PC3. Wait for switch convergence or click Fast Forward Time a few times. Part 1: Test Connectivity Without Inter-VLAN Routing Step 1: Ping between PC1 and PC3. Finally, you will enable trunking and verify connectivity between VLANs. You will then configure VLANs and inter-VLAN routing. In this activity, you will check for connectivity prior to implementing inter-VLAN routing. Part 4: Test Connectivity with Inter-VLAN Routing Scenario Part 1: Test Connectivity without Inter-VLAN Routing Issue the show interface trunk command to verify that the interface is configured as a trunk Step 3: Test Connectivity If the configurations are correct, PC1 and PC3 should be able to ping their default gateways and each other.6.3.3.6 Packet Tracer вЂ“ Configuring Router-on-a-Stick Inter-VLAN Routing Addressing Table Device How can you determine that the interface is a trunk port using the show vian command? d. Because the router was configured with multiple sub interfaces assigned to different VLANs, the switch port connecting to the router must be configured as a trunk. Use the show in interface brief command to verify sub interface configuration Part 3: Test Connectivity with Inter-VLAN Routing Step 1: Ping between PC1, Pc2 and PC3. Part 2: Configure Sub interfaces Step 1: Configure sub interfaces on R1 using the 802.1Q encapsulation. Create VLANs on 31 Step 2: Assign interfaces on the switch to VLANS. Part 1: Add VLANs to a Switch Step 1: Create VLANs on S1. You will then enable trunk interfaces and verify connectivity between VLANs.

Router on a stick packet tracer